Salta al contenuto principale
Aiuto

Sony Vaio PCG-7A2L RAM Replacement

This guide helps users replace the RAM in the Sony Vaio PCG-7A2L laptop.

Sezioni
Strumenti

Passo 1 RAM  ¶ 

To remove the RAM, use sharp end of a spudger to push the two silver tabs (see picture) away from the green RAM chip. When both silver tabs are moved to the side, one edge of the RAM chip will pop up from its original position. Use your fingers to grab the raised edge of the RAM and pull the chip away from its connection to the laptop.

Passo 1 RAM  ¶ 

  • To remove the RAM, use sharp end of a spudger to push the two silver tabs (see picture) away from the green RAM chip.

  • When both silver tabs are moved to the side, one edge of the RAM chip will pop up from its original position.

  • Use your fingers to grab the raised edge of the RAM and pull the chip away from its connection to the laptop.

Passo 2  ¶ 

To install the new RAM, grip the new chip exactly the same way as you gripped the old chip when you removed it.

Passo 2  ¶ 

  • To install the new RAM, grip the new chip exactly the same way as you gripped the old chip when you removed it.

  • Insert the gold leads of the RAM into the connection at the same angle the original chip was raised at after the tabs were released.

  • There is a raised tab on the connection that mates with a slit in the RAM to ensure you do not put the chip in upside down.

Passo 3  ¶ 

To finish the RAM installation, use your finger to push down on the center of the RAM until it clips into the silver tabs and locks into place.

Passo 3  ¶