Salta al contenuto principale
Aiuto

HP 2000 - 2D22DX Hard Drive Replacement

How to replace a HP 2000 - 2D22DX hard drive.

  • Autore: Conor Most
  • Stima il tempo: 5 - 10 minuti
  • Difficoltà: Moderato

A good hard drive is essential to an optimally performing computer. If your computer is slowing down, a new hard drive may be exactly what your device needs to start functioning at its maximum potential.

Passo 1 Hard Drive  ¶ 

Loosen the Phillips #00 screw securing the RAM compartment cover. The screw is permanently attached to the RAM compartment cover. Do not try to remove it completely.

Passo 1 Hard Drive  ¶ 

  • Loosen the Phillips #00 screw securing the RAM compartment cover.

  • The screw is permanently attached to the RAM compartment cover. Do not try to remove it completely.

Passo 2  ¶ 

Once the screw is sufficiently loosened, slowly unclip the RAM compartment cover from its slots in the plastic chassis. When unclipped completely, pull the compartment door out and away from the chassis.

Passo 2  ¶ 

  • Once the screw is sufficiently loosened, slowly unclip the RAM compartment cover from its slots in the plastic chassis.

  • When unclipped completely, pull the compartment door out and away from the chassis.

Passo 3  ¶ 

Loosen the two Phillips #00 screws that are securing the hard drive compartment. The screws are permanently attached to the hard drive compartment cover. Do not try to remove them completely. Once the screws are sufficiently loosened, disconnect the clips holding the cover in place and slowly pull the cover away from the plastic chassis.

Passo 3  ¶ 

  • Loosen the two Phillips #00 screws that are securing the hard drive compartment.

  • The screws are permanently attached to the hard drive compartment cover. Do not try to remove them completely.

  • Once the screws are sufficiently loosened, disconnect the clips holding the cover in place and slowly pull the cover away from the plastic chassis.

Passo 4  ¶ 

Using a spudger, disconnect the hard drive connecting cable. Use a slow, prying motion as if pulling a nail out of wood. Be very gentle with the connecting cable and its respective port on the logic board. Both are very fragile and can be easily damaged. Be very gentle with the connecting cable and its respective port on the logic board. Both are very fragile and can be easily damaged.

Passo 4  ¶ 

  • Using a spudger, disconnect the hard drive connecting cable. Use a slow, prying motion as if pulling a nail out of wood.

  • Be very gentle with the connecting cable and its respective port on the logic board. Both are very fragile and can be easily damaged.

Passo 5  ¶ 

Using your fingers, grab the blue tab on the right side of the hard drive and slowly pull upwards. Lift the hard drive out and away from its socket in the plastic chassis. Lift the hard drive out and away from its socket in the plastic chassis.

Passo 5  ¶ 

  • Using your fingers, grab the blue tab on the right side of the hard drive and slowly pull upwards.

  • Lift the hard drive out and away from its socket in the plastic chassis.