Salta al contenuto principale
Aiuto

Sega Game Gear Screen Replacement

Guida In Evidenza

Guida In Evidenza

Questa guida è stata giudicata eccezionalmente ben fatta dallo staff iFixit.

Use this guide to instal a replacement screen.

  • Autore: Lauren Thurston
  • Stima il tempo: 30 - 45 minuti
  • Difficoltà: Moderato

A guide to installing a replacement screen on a Sega Game Gear.

Sezioni
Strumenti

Passo 1 Screen  ¶ 

Unscrew all the marked screws.

Passo 1 Screen  ¶ 

  • Unscrew all the marked screws.

Passo 2  ¶ 

Slide the logic board out from under the circular black fastener at the top-left corner of the case.

Passo 2  ¶ 

  • Slide the logic board out from under the circular black fastener at the top-left corner of the case.

Passo 3  ¶ 

Place the board onto a flat surface.

Passo 3  ¶ 

  • Place the board onto a flat surface.

  • Small plastic buttons may fall off during this process, save them in a container or a place where they could be found later on.

Passo 4  ¶ 

Unscrew the marked screws.

Passo 4  ¶ 

  • Unscrew the marked screws.

  • Flip the board, having its back facing up.

  • Hold onto the screen in the back, as it will flip open if not held onto.

Passo 5  ¶ 

Make sure the screen is towards the bottom, as indicated in the second picture. Make sure the screen is towards the bottom, as indicated in the second picture.

Passo 5  ¶ 

  • Make sure the screen is towards the bottom, as indicated in the second picture.

Passo 6  ¶ 

Gently open the screen up. The screen will not come out all the way since it is glued onto the top side.

Passo 6  ¶ 

  • Gently open the screen up.

  • The screen will not come out all the way since it is glued onto the top side.