Salta al contenuto principale
Aiuto

PowerBook G4 Aluminum 15" 1-1.5 GHz Display Replacement

Guida In Evidenza

Guida In Evidenza

Questa guida è stata giudicata eccezionalmente ben fatta dallo staff iFixit.

  • Autore: iRobot
  • Difficoltà: Difficile

Change out the entire display assembly, including the inverter, Airport antenna, hinges and metal casing.

Passo 1 Display  ¶ 

If you have already removed the hard drive or optical drive, your computer may differ slightly from the images in this section. These parts do not affect this procedure.

Passo 1 Display  ¶ 

  • If you have already removed the hard drive or optical drive, your computer may differ slightly from the images in this section. These parts do not affect this procedure.

  • Close the display and turn the hinge side of the computer to face you.

  • Remove the remaining Phillips screw on either side of the hinge (two screws total).

Passo 2  ¶ 

Open the computer with the display facing you.

Passo 2  ¶ 

  • Open the computer with the display facing you.

  • Use a spudger to pry the bluetooth board from the gap between the battery housing and front of the lower case.

Passo 3  ¶ 

Disconnect the bluetooth antenna cable from the bluetooth board.

Passo 3  ¶ 

  • Disconnect the bluetooth antenna cable from the bluetooth board.

  • Deroute the bluetooth antenna cable along the left edge of the computer, removing tape as necessary.

Passo 4  ¶ 

Disconnect the large orange Airport ribbon from the logic board.

Passo 4  ¶ 

  • Disconnect the large orange Airport ribbon from the logic board.

Passo 5  ¶ 

Pull the Airport ribbon cable up in order to access the black Airport antenna connector.

Passo 5  ¶ 

  • Pull the Airport ribbon cable up in order to access the black Airport antenna connector.

  • Disconnect the Airport antenna cable at the black connector, making sure you pull only on the black rubber portion of the connector.

Passo 6  ¶ 

Disconnect the inverter cable from the logic board.

Passo 6  ¶ 

  • Disconnect the inverter cable from the logic board.

Passo 7  ¶ 

Remove the two pieces of orange tape covering the display data cable and disconnect the cable from the logic board.

Passo 7  ¶ 

  • Remove the two pieces of orange tape covering the display data cable and disconnect the cable from the logic board.

Passo 8  ¶ 

Make sure you've freed up all four cables attached to the display assembly, and will pull away easily with the rest of the display.

Passo 8  ¶ 

  • Make sure you've freed up all four cables attached to the display assembly, and will pull away easily with the rest of the display.

  • Remove the T8 Torx screw closer to the display on either side of the hinge (two screws total).

Passo 9  ¶ 

Be sure to support the display with one hand while removing the final two screws.

Passo 9  ¶ 

  • Be sure to support the display with one hand while removing the final two screws.

  • Remove the longer T8 Torx screw remaining on either hinge (two screws total).

Passo 10  ¶ 

Lift the display off.

Passo 10  ¶ 

  • Lift the display off.