Salta al contenuto principale
Aiuto

DualShock 4 Charging Port Replacement

Remove the charging port in the Dualshock 4 controller.

This guide provides a step-by-step process of how to replace a charging port in the DualShock 4 controller.

Passo 1 Charging Port  ¶ 

Detach the motherboard ribbon connecting the two sides of the controller by using your fingers. After the two halves are separated, place the top of the controller off to the side. After the two halves are separated, place the top of the controller off to the side.

Passo 1 Charging Port  ¶ 

  • Detach the motherboard ribbon connecting the two sides of the controller by using your fingers.

  • After the two halves are separated, place the top of the controller off to the side.

Passo 2  ¶ 

Remove the two screws holding the sub-assembly together. Then use the blunt forceps to grab the 2 inch black plastic connector labeled in the picture with the red box. Use the blunt forceps to grab the 2 inch white piece of plastic labeled with the orange box. Use the blunt forceps to grab the 2 inch white piece of plastic labeled with the orange box.

Passo 2  ¶ 

  • Remove the two screws holding the sub-assembly together. Then use the blunt forceps to grab the 2 inch black plastic connector labeled in the picture with the red box.

  • Use the blunt forceps to grab the 2 inch white piece of plastic labeled with the orange box.

Passo 3  ¶ 

With the clear piece of plastic pushed in, take the transparent white piece out from the top of the controller. Keep the clear plastic piece on the controller, but keep it pushed down to provide room for charger port replacement. Use the Philips #00 Screwdriver to unscrew the two 4.0 mm screws that attach the charging port to the rear cover.

Passo 3  ¶ 

  • With the clear piece of plastic pushed in, take the transparent white piece out from the top of the controller.

  • Keep the clear plastic piece on the controller, but keep it pushed down to provide room for charger port replacement.

  • Use the Philips #00 Screwdriver to unscrew the two 4.0 mm screws that attach the charging port to the rear cover.

Passo 4  ¶ 

With the blunt forceps remove the top part of the black tape connecting the charging port to the plastic portion of the controller. Grab the PCB of the charging port from the side and pull upwards slowly to remove from the controller. Do NOT pull the blue PCB rapidly upwards; instead move the piece side to side to create some free space between the controller and PCB.

Passo 4  ¶ 

  • With the blunt forceps remove the top part of the black tape connecting the charging port to the plastic portion of the controller.

  • Grab the PCB of the charging port from the side and pull upwards slowly to remove from the controller.

  • Do NOT pull the blue PCB rapidly upwards; instead move the piece side to side to create some free space between the controller and PCB.