Salta al contenuto principale
Aiuto

Nikon D70 Rear Cover Assembly Replacement

Remove the rear cover assembly to access the LCD and other components.

Passo 1 Rear Cover Assembly  ¶ 

Remove the two 4.8 mm Phillips screws securing the battery side of the rear cover to the D70.

Passo 1 Rear Cover Assembly  ¶ 

  • Remove the two 4.8 mm Phillips screws securing the battery side of the rear cover to the D70.

Passo 2  ¶ 

Remove the two 4.8 mm Phillips screws securing the port side of the rear cover to the D70.

Passo 2  ¶ 

  • Remove the two 4.8 mm Phillips screws securing the port side of the rear cover to the D70.

Passo 3  ¶ 

Use your fingernail to flip up the ZIF locking flap on the LCD ribbon cable socket. Be sure you are opening the locking tab, not pulling against the socket mounted to the board.

Passo 3  ¶ 

  • Use your fingernail to flip up the ZIF locking flap on the LCD ribbon cable socket.

  • Be sure you are opening the locking tab, not pulling against the socket mounted to the board.

  • Pull the LCD board ribbon cable out of its socket.

Passo 4  ¶ 

Carefully pull the sides of the rear cover away from the body of the D70. Carefully pull the sides of the rear cover away from the body of the D70.

Passo 4  ¶ 

  • Carefully pull the sides of the rear cover away from the body of the D70.

Passo 5  ¶ 

Pull the rear cover off the body of the D70, minding the LCD board ribbon cable that may get caught. At this point, the capacitor is visible and its exposed contacts are boxed in red in the second picture. Even though they are recessed, be careful not to touch the contacts to avoid shocking yourself.

Passo 5  ¶ 

  • Pull the rear cover off the body of the D70, minding the LCD board ribbon cable that may get caught.

  • At this point, the capacitor is visible and its exposed contacts are boxed in red in the second picture. Even though they are recessed, be careful not to touch the contacts to avoid shocking yourself.