Salta al contenuto principale
Aiuto

Detach the Behringer Eurolive B212D Electronics Box

Potenzialmente Pericoloso

Potenzialmente Pericoloso

Possibilità di infortunio se questa procedura non viene seguita correttamente. Prestare attenzione e seguire tutte le avvertenze.

Guida con Contributo Membro

Guida con Contributo Membro

Uno straordinario membro della nostra comunità ha realizzato questa guida. Non è gestita dallo staff iFixit.

Testo Confuso

Testo Confuso

Parte del testo di questa guida è confusionario, doppio, o fuori tema. Modificarlo per renderlo più chiaro!

Necessarie Immagini Migliori

Necessarie Immagini Migliori

Delle foto più belle renderanno migliore questa guida. Contribuisci scattando, modificando o caricando immagini nuove!

Detaching the metal electronics box is necessary to accessing or replacing any other subsystems.

  • Autore: gameslammer7
  • Stima il tempo: 10 - 15 minuti
  • Difficoltà: Moderato

This is a prerequisite for working any further on the electronics box. It is far easier to set aside the speaker casing and work on the electronics box alone.

Passo 1 Electronics Box Detachment  ¶ 

There are two silver, 6 mm-long machine screws with two 1/8" inner-diameter washers on the exterior of the metal electronics box; remove these first using a #2 philips screwdriver. There are five of the same type of machine screw (silver, 6 mm-long) remaining around the metal electronics box's exterior; remove these as well. You should have removed a total of 7 machine screws and 2 washers.

Passo 1 Electronics Box Detachment  ¶ 

  • There are two silver, 6 mm-long machine screws with two 1/8" inner-diameter washers on the exterior of the metal electronics box; remove these first using a #2 philips screwdriver.

  • There are five of the same type of machine screw (silver, 6 mm-long) remaining around the metal electronics box's exterior; remove these as well.

  • You should have removed a total of 7 machine screws and 2 washers.

  • The reason for removing the two screws with the two washers first (or replacing them last when reassembling) is that their holes are actually slots. They are designed as slots to accommodate slop in the assembly, and if unscrewed out of order, you may have difficulty while removing - or possibly even damage - the other five screws.

Passo 2  ¶ 

Remove the portion of the metal housing that you freed with the 7 screws in the previous step.

Passo 2  ¶ 

  • Remove the portion of the metal housing that you freed with the 7 screws in the previous step.

Passo 3  ¶ 

Inside the metal electronics box housing is a white clip attached to a small PCB; remove this. The white clip in this image has been glued, indicating that the manufacturer may not expect  the end user to remove this clip; it is difficult to proceed with the disassembling without doing so, however, because the rest of the speaker does not provide a sufficient surface on which to work. Snake the clip head through the hole in the metal electronics box casing.

Passo 3  ¶ 

  • Inside the metal electronics box housing is a white clip attached to a small PCB; remove this.

  • The white clip in this image has been glued, indicating that the manufacturer may not expect the end user to remove this clip; it is difficult to proceed with the disassembling without doing so, however, because the rest of the speaker does not provide a sufficient surface on which to work.

  • Snake the clip head through the hole in the metal electronics box casing.