iPad Mini Wi-Fi Logic Board Replacement
Replace the Logic Board and Lightning port in your iPad Mini Wi-Fi.
- Autore: Sam Goldheart
- Difficoltà: Molto difficile
Use this guide to replace the logic board and Lightning port. The Lightning port is soldered on to the logic board and the two must be replaced as a unit.
Incorpora questa guida
Scegli una dimensione e copia il codice qui sotto per incorporare questa guida come un piccolo widget sul tuo sito / forum.
- iOpener Heating 3 passi
- Front Panel 27 passi
- LCD Assembly 17 passi
- LCD Shield Plate 3 passi
- Battery Connector 3 passi
- LCD 4 passi
- Front Panel Assembly 3 passi
- Battery 12 passi
- Logic Board Assembly 24 passi
- Plastic Covers 2 passi
- Wi-Fi/Bluetooth Antenna 6 passi
- GPS Antenna 2 passi
- Speakers 7 passi
- Logic Board 9 passi
Passo 1 — Logic Board ¶
Reheat the iOpener in the microwave for one minute.
Place the heated iOpener on the left side of the back of the iPad. Let it sit there for 90 seconds to soften the logic board adhesive.
Passo 2 ¶
Slide the flat end of a spudger underneath the Lightning port cable, freeing it from the adhesive securing it to the rear case.
Passo 3 ¶
Continue to carefully slide the spudger under the Lightning port cable nearest the logic board.
Passo 4 ¶
Gently insert the flat end of a spudger underneath the logic board nearest the front-facing camera. Slowly pry to free the corner from adhesive.
Passo 5 ¶
Insert the flat end of a spudger underneath the center of the logic board. Slowly pry to free the section from adhesive.
Passo 6 ¶
Insert the spudger underneath the logic board nearest the Lightning port cable and pry to free the corner.
Passo 7 ¶
Insert the spudger further under the logic board and slide along its length to detach the last of the adhesive.
Passo 8 ¶
Lift the end of the logic board nearest the front-facing camera to ensure it is free of adhesive.
Passo 9 ¶
Lift the logic board and Lightning cable assembly up and pull toward the top of the iPad to remove the Lightning connector from its housing.