Salta al contenuto principale
Aiuto

Seagate 3TB Expansion Desktop Drive Teardown

Smontaggio

Smontaggio

Gli smontaggi danno un'immagine dell'interno di device e non dovrebbero essere usati come istruzioni di smontaggio.

Foto Azione

Foto Azione

Passa all'azione, eroe! Questa guida ha bisogno di immagini che meglio illustrano come eseguire azioni specifiche.

Guida con Contributo Membro

Guida con Contributo Membro

Uno straordinario membro della nostra comunità ha realizzato questa guida. Non è gestita dallo staff iFixit.

First attempt at a tear down of Seagates 3TB External Drive.

Passo 1 Seagate 3TB Expansion Desktop Drive Teardown  ¶ 

Start at the plain end (the opposite side from the power jack) with the spudger. Carefully pry slightly up and away.

Passo 1 Seagate 3TB Expansion Desktop Drive Teardown  ¶ 

  • Start at the plain end (the opposite side from the power jack) with the spudger. Carefully pry slightly up and away.

  • Once you have the end opened up, use the credit card to hold it open.

  • When you have the entire end separated, carefully pry the sides out and away along the adjoining two sides, working your way towards the end with the power jack. Save that end for last, it should lift away when you're done with the other sides.

Passo 2  ¶ 

Work around the drive, ends first then the sides to open it This is really challenging and I did end up breaking some of the clips. Its pretty hard to tear apart. This is really challenging and I did end up breaking some of the clips. Its pretty hard to tear apart.

Passo 2  ¶ 

  • Work around the drive, ends first then the sides to open it

  • This is really challenging and I did end up breaking some of the clips. Its pretty hard to tear apart.

Passo 3  ¶ 

Gently pull the sides slightly and the drive will lift out

Passo 3  ¶ 

  • Gently pull the sides slightly and the drive will lift out

Passo 4  ¶ 

Pull the rubber screw covers off, these are mounted with a little glue and came off easily Remove all four screws with the philips screwdriver Remove all four screws with the philips screwdriver

Passo 4  ¶ 

  • Pull the rubber screw covers off, these are mounted with a little glue and came off easily

  • Remove all four screws with the philips screwdriver

Passo 5  ¶ 

Slide drive out of metal caddy (do not lift) You will now have a SATA Hard Drive and the caddy separate You will now have a SATA Hard Drive and the caddy separate

Passo 5  ¶ 

  • Slide drive out of metal caddy (do not lift)

  • You will now have a SATA Hard Drive and the caddy separate

Passo 6  ¶ 

From the bottom of the caddy there are two black screws With the Philips screwdriver you can remove these Pull the circuit board gently and evenly to remove it

Passo 6  ¶ 

  • From the bottom of the caddy there are two black screws

  • With the Philips screwdriver you can remove these

  • Pull the circuit board gently and evenly to remove it