Salta al contenuto principale
Aiuto

RedOctane X-Plorer Teardown

Smontaggio

Smontaggio

Gli smontaggi danno un'immagine dell'interno di device e non dovrebbero essere usati come istruzioni di smontaggio.

Guida con Contributo Membro

Guida con Contributo Membro

Uno straordinario membro della nostra comunità ha realizzato questa guida. Non è gestita dallo staff iFixit.

The screws could be torx or Philips head in the body and where the neck bolts to the body.

Passo 1 Case  ¶ 

Remove all 16 #10-torx screws from the back side of the case.

Passo 1 Case  ¶ 

  • Remove all 16 #10-torx screws from the back side of the case.

  • Gently separate the case pieces.

  • A strong magnet helps greatly when taking out the screws.

  • Keep in mind when resembling, the case is plastic so, don't tighten the screws too tight.

Passo 2 Neck  ¶ 

Unscrew the 4 #10-torx screws.

Passo 2 Neck  ¶ 

  • Unscrew the 4 #10-torx screws.

Passo 3 Colored Keys  ¶ 

Unscrew the 2 Philips head screws Peel off the pads. Push the colored keys out from the other side.

Passo 3 Colored Keys  ¶ 

  • Unscrew the 2 Philips head screws

  • Peel off the pads.

  • Push the colored keys out from the other side.

Passo 4 Strum Bar  ¶ 

Unscrew the red screws and pull the board out. Then, unscrew the blue screws Pull the bracket things off.

Passo 4 Strum Bar  ¶ 

  • Unscrew the red screws and pull the board out.

  • Then, unscrew the blue screws

  • Pull the bracket things off.

  • Pull out the pin.

Passo 5 Unused port  ¶ 

Unscrew the 4 Philips head screws.

Passo 5 Unused port  ¶ 

  • Unscrew the 4 Philips head screws.

Passo 6 Aux Port  ¶ 

Unscrew these 2 Philips head screws.

Passo 6 Aux Port  ¶ 

  • Unscrew these 2 Philips head screws.

Passo 7 Whammy Bar  ¶ 

Push from the other side until it comes out. Take the spring off with the connector

Passo 7 Whammy Bar  ¶ 

  • Push from the other side until it comes out.

  • Take the spring off with the connector

Passo 8 Motherboard  ¶ 

Unscrew the 4 Philips head screws. Peel off the contact pads.

Passo 8 Motherboard  ¶ 

  • Unscrew the 4 Philips head screws.

  • Peel off the contact pads.