Salta al contenuto principale
Aiuto

HP Mini 210-2070NR Keyboard Replacement

Inconveniente Markup

Inconveniente Markup

Questa guida ha bisogno di markup migliori. Contribuisci correggendoli o con annotazioni sui markup.

Fallo a Fettine

Fallo a Fettine

I passaggi in questa guida dovrebbero essere suddivisi e trasformati in una serie di guide prerequisite.

This is a step by step guide showing how to install a new keyboard.

  • Autore: Sean Kuster
  • Stima il tempo: 15 - 20 minuti
  • Difficoltà: Moderato

Use this guide to remove and install a new keyboard as a whole.

Passo 1 Keyboard  ¶ 

Using a 00 Phillips screwdriver, unscrew and remove the three 2.0 X 5.0 screws that connect the keyboard to the computer. Each of the screws are labeled with small keyboards next to them.

Passo 1 Keyboard  ¶ 

  • Using a 00 Phillips screwdriver, unscrew and remove the three 2.0 X 5.0 screws that connect the keyboard to the computer.

  • Each of the screws are labeled with small keyboards next to them.

  • Flip the computer over so that the front is facing you.

Passo 2  ¶ 

Open the computer screen as far as possible. It should be able to lay flat on whatever surface you are working on. Pry along the rear edge of the keyboard away from the PC with the plastic opening tool. Once enough of an opening has been established, gently grasp the edge and pull the keyboard towards you.

Passo 2  ¶ 

  • Open the computer screen as far as possible. It should be able to lay flat on whatever surface you are working on.

  • Pry along the rear edge of the keyboard away from the PC with the plastic opening tool.

  • Once enough of an opening has been established, gently grasp the edge and pull the keyboard towards you.

  • There is a cable connecting the keyboard to the laptop, so do not attempt to fully remove the keyboard yet or you will damage your device.

Passo 3  ¶ 

Use your fingernail to flip up the black retaining flap attached to the keyboard ZIF connector. Pull the keyboard cable out of its socket to disconnect it.

Passo 3  ¶ 

  • Use your fingernail to flip up the black retaining flap attached to the keyboard ZIF connector.

  • Pull the keyboard cable out of its socket to disconnect it.

Passo 4  ¶ 

Remove the keyboard by lifting it away from the computer.

Passo 4  ¶ 

  • Remove the keyboard by lifting it away from the computer.