Salta al contenuto principale
Aiuto

HP Mini 210-2070NR Hard Drive Replacement

Inconveniente Markup

Inconveniente Markup

Questa guida ha bisogno di markup migliori. Contribuisci correggendoli o con annotazioni sui markup.

Fallo a Fettine

Fallo a Fettine

I passaggi in questa guida dovrebbero essere suddivisi e trasformati in una serie di guide prerequisite.

Vigilanza sulla Grammatica

Vigilanza sulla Grammatica

Adotta il tuo insegnante di inglese interno e contribuisci a migliorare la grammatica di questa guida!

Testo Confuso

Testo Confuso

Parte del testo di questa guida è confusionario, doppio, o fuori tema. Modificarlo per renderlo più chiaro!

This a step by step guide showing how to replace your hard drive.

  • Autore: Alek Linquist
  • Stima il tempo: 20 minuti
  • Difficoltà: Moderato

Use this guide to remove and install a new hard drive.

Passo 1 Hard Drive  ¶ 

Locate the HP product sticker, a black square sticker covered with product details, at the top of the computer. Pull off the HP product sticker, starting at the top right corner and pulling diagonally down towards the bottom right. Be careful not to pull up the black hard drive plastic connector with the sticker. Also, removing this sticker will void your warranty.

Passo 1 Hard Drive  ¶ 

  • Locate the HP product sticker, a black square sticker covered with product details, at the top of the computer.

  • Pull off the HP product sticker, starting at the top right corner and pulling diagonally down towards the bottom right.

  • Be careful not to pull up the black hard drive plastic connector with the sticker. Also, removing this sticker will void your warranty.

  • Remove the HP product sticker.

Passo 2  ¶ 

Locate the hard drive, where the HP Product sticker used to be. Locate the hard drive cable, connected to the hard drive.

Passo 2  ¶ 

  • Locate the hard drive, where the HP Product sticker used to be.

  • Locate the hard drive cable, connected to the hard drive.

  • Disconnect the hard drive cable by gently pulling upward.

Passo 3  ¶ 

Using a 00 Phillips screwdriver, unscrew and remove the three 2.0 x 4.0 Philips screws holding the hard drive in place. Using a 00 Phillips screwdriver, unscrew and remove the three 2.0 x 4.0 Philips screws holding the hard drive in place.

Passo 3  ¶ 

  • Using a 00 Phillips screwdriver, unscrew and remove the three 2.0 x 4.0 Philips screws holding the hard drive in place.

Passo 4  ¶ 

Use the Mylar Tab located on the right side of the hard drive to pry up the hard drive. Remove the hard drive.

Passo 4  ¶ 

  • Use the Mylar Tab located on the right side of the hard drive to pry up the hard drive.

  • Remove the hard drive.

Passo 5  ¶ 

Lay the hard drive down with the underside facing up.

Passo 5  ¶ 

  • Lay the hard drive down with the underside facing up.

  • Pull and remove the hard drive pin connector from the hard drive.