Salta al contenuto principale
Aiuto

Power Macintosh G3 Blue and White Modem Replacement

Guida con Contributo Membro

Guida con Contributo Membro

Uno straordinario membro della nostra comunità ha realizzato questa guida. Non è gestita dallo staff iFixit.

Modem assembly not working or broken? Replace it! This is not meant to be confused with the Ethernet assembly.

  • Autore: Aaron Cooke
  • Stima il tempo: 9 - 15 minuti
  • Difficoltà: Facile

I wasn’t able to find a replacement modem assembly online so you are on your own for that part.

Passo 1 Before opening up your Power Mac...  ¶ 

Remove the Phillips #1 screw circled in the picture. Set it aside for re-assembly.

Passo 1 Before opening up your Power Mac...  ¶ 

  • Remove the Phillips #1 screw circled in the picture. Set it aside for re-assembly.

Passo 2  ¶ 

Unfortunately, I am unable to provide OG content for this step due to my Power Mac’s outer case being severely damaged. Once I get my new outer case I will update this step.

Passo 2  ¶ 

  • Unfortunately, I am unable to provide OG content for this step due to my Power Mac’s outer case being severely damaged. Once I get my new outer case I will update this step.

  • Lift the latch on the right side panel to reveal the internals.

  • If you are doing this on a hard surface I highly suggest you put a mat down between the door and the ground to prevent scratches.

Passo 3  ¶ 

Remove the single Phillips #1 screw circled in the picture.

Passo 3  ¶ 

  • Remove the single Phillips #1 screw circled in the picture.

  • I apologize for the lack of picture quality. The only camera and lighting I had were my iPhone X´s camera and a table lamp. Lol!

Passo 4  ¶ 

Disconnect the modem’s flex cable from the connector  on the logic board.

Passo 4  ¶ 

  • Disconnect the modem’s flex cable from the connector on the logic board.

Passo 5  ¶ 

Nessuna immagine

Passo 5  ¶ 

  • Lift the modem assembly out of it´s place on the logic board.