Salta al contenuto principale
Aiuto

Altec Lansing BoomJacket 2 Disassembly

This guide will show you how to disassemble your BoomJacket 2.

  • Autore: Zach Braaten
  • Stima il tempo: 5 - 15 minuti
  • Difficoltà: Moderato

After completing this guide you will be ready to repair or replace any of the components inside your device.

Strumenti
Componenti Rilevanti

Passo 1 Altec Lansing BoomJacket 2 Disassembly  ¶ 

Starting from any side, use your fingers to grab the black rubber sleeve and gently pull away from the speaker on both sides. Starting from any side, use your fingers to grab the black rubber sleeve and gently pull away from the speaker on both sides.

Passo 1 Altec Lansing BoomJacket 2 Disassembly  ¶ 

  • Starting from any side, use your fingers to grab the black rubber sleeve and gently pull away from the speaker on both sides.

Passo 2  ¶ 

Using your fingers, grab the blue sleeve from one side and pull away from the unit. Using your fingers, grab the blue sleeve from one side and pull away from the unit.

Passo 2  ¶ 

  • Using your fingers, grab the blue sleeve from one side and pull away from the unit.

Passo 3  ¶ 

At each of the marked pry spots,  use the metal spudger to lift the speaker grill away from the case.

Passo 3  ¶ 

  • At each of the marked pry spots, use the metal spudger to lift the speaker grill away from the case.

  • Avoid using excessive force to prevent bending the grill.

Passo 4  ¶ 

Use the tweezers to remove the six rubber stoppers. There are four in the middle and two on the sides. Use the tweezers to remove the six rubber stoppers. There are four in the middle and two on the sides.

Passo 4  ¶ 

  • Use the tweezers to remove the six rubber stoppers. There are four in the middle and two on the sides.

Passo 5  ¶ 

Use the PH1 Phillips screwdriver to remove the six 12mm screws that lie underneath each rubber stopper.

Passo 5  ¶ 

  • Use the PH1 Phillips screwdriver to remove the six 12mm screws that lie underneath each rubber stopper.

Passo 6  ¶ 

Gently pull apart the front panel from the base of the speaker.

Passo 6  ¶ 

  • Gently pull apart the front panel from the base of the speaker.