Salta al contenuto principale
Aiuto

Dell Inspiron n5110 Display Assembly Replacement

Guida con Contributo Membro

Guida con Contributo Membro

Uno straordinario membro della nostra comunità ha realizzato questa guida. Non è gestita dallo staff iFixit.

  • Autore: Terrence15
  • Stima il tempo: 4 - 7 minuti
  • Difficoltà: Moderato

In this guide, we will be showing you how to remove and replace the Display Assembly.

Passo 1 Remove the Screws  ¶ 

WARNING: Before working inside your computer, read the safety information that shipped with your computer. Follow the instructions in "Before You Begin".

Passo 1 Remove the Screws  ¶ 

  • WARNING: Before working inside your computer, read the safety information that shipped with your computer. Follow the instructions in "Before You Begin".

  • CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer).

  • Remove the two screws that secure the display assembly to the computer base.

Passo 2 Disconnecting the Display Cable  ¶ 

Disconnect the display cable and touch-screen cable from the system-board connectors.

Passo 2 Disconnecting the Display Cable  ¶ 

  • Disconnect the display cable and touch-screen cable from the system-board connectors.

  • NOTE: The touch-screen board is optional and may not be present in your computer.

Passo 3 Note the Routing  ¶ 

Note the routing of the Mini-Card antenna cables and remove the cables from the routing guides.

Passo 3 Note the Routing  ¶ 

  • Note the routing of the Mini-Card antenna cables and remove the cables from the routing guides.

Passo 4 Remove the Screws  ¶ 

Remove the four screws that secure the display assembly to the computer base.

Passo 4 Remove the Screws  ¶ 

  • Remove the four screws that secure the display assembly to the computer base.

Passo 5 Lifting the Display Assembly.  ¶ 

Lift the display assembly off the computer base.

Passo 5 Lifting the Display Assembly.  ¶ 

  • Lift the display assembly off the computer base.

Passo 6 Placing the Display Assembly  ¶ 

Place the NEW display assembly in position and replace the four screws that secure the display assembly to the computer base.

Passo 6 Placing the Display Assembly  ¶ 

  • Place the NEW display assembly in position and replace the four screws that secure the display assembly to the computer base.

Passo 7 Route the Cables  ¶ 

Route the Mini-Card antenna cables through the routing guides.

Passo 7 Route the Cables  ¶ 

  • Route the Mini-Card antenna cables through the routing guides.

Passo 8 Connect the Display Cable  ¶ 

Connect the display cable and touch-screen cable to the connectors on the system board.

Passo 8 Connect the Display Cable  ¶ 

  • Connect the display cable and touch-screen cable to the connectors on the system board.

Passo 9 Replace the Screws  ¶ 

Replace the two screws that secure the display assembly to the computer base.

Passo 9 Replace the Screws  ¶ 

  • Replace the two screws that secure the display assembly to the computer base.