Salta al contenuto principale
Aiuto

LG Neon II Slider Mechanism Replacement

Foto Azione

Foto Azione

Passa all'azione, eroe! Questa guida ha bisogno di immagini che meglio illustrano come eseguire azioni specifiche.

Attrezzi Non Corretti

Attrezzi Non Corretti

Contribuisci a rendere migliore questa guida usando i giusti strumenti nelle immagini e/o nel testo.

This guide will show you how to access the slider mechanism inside the phone.

  • Autore: Daniel Min
  • Stima il tempo: 15 minuti
  • Difficoltà: Moderato

If your LG Neon II won't slide the way it should be the springs probably need to be replaced. This guide will show you how.

Passo 1 Slider Mechanism  ¶ 

Remove the three 1.75 mm screws.

Passo 1 Slider Mechanism  ¶ 

  • Remove the three 1.75 mm screws.

Passo 2  ¶ 

Using the plastic opening tool, lift up the circuit board on the side opposite the speaker. This will reveal the sliding mechanism located under the screen. The two halves of the phone will still be attached.

Passo 2  ¶ 

  • Using the plastic opening tool, lift up the circuit board on the side opposite the speaker. This will reveal the sliding mechanism located under the screen.

  • The two halves of the phone will still be attached.

Passo 3  ¶ 

Each of the two springs are connected to two little knotches. You may need to slide the slider to clearly see the image shown.

Passo 3  ¶ 

  • Each of the two springs are connected to two little knotches. You may need to slide the slider to clearly see the image shown.

  • The two knotches are easily visible in the slot on the left within the red square.

  • Take your replacement spring and stretch it between these two knotches and the slider should work fine.