Salta al contenuto principale
Aiuto

iPhone 8 Plus Rear-Facing Cameras Replacement

Replace the dual, rear-facing camera assembly in the iPhone 8 Plus.

  • Autore: Jeff Suovanen
  • Stima il tempo: 1 ora
  • Difficoltà: Moderato

Use this guide to remove and replace the dual rear cameras in the iPhone 8 Plus. The rear camera assembly consists of two individual modules: one wide-angle camera and one telephoto camera.

Note: This guide instructs you to completely detach the display cables and remove the display assembly in order to better access the rear cameras—however, it's possible to remove and replace the rear cameras with the display cables still connected. Advanced readers may skip disconnecting the display in order to save time, as long as the display is properly supported and the display cables are not damaged.

Passo 1 Rear-Facing Cameras  ¶ 

Remove the two Y000 screws securing the rear camera connector cover bracket: One 1.4 mm screw

Passo 1 Rear-Facing Cameras  ¶ 

  • Remove the two Y000 screws securing the rear camera connector cover bracket:

  • One 1.4 mm screw

  • One 1.4 mm (nonferrous) screw

  • This screw tends to not be attracted to a magnetized screwdriver. Make sure to reinstall it in the correct place—a magnetized screw may interfere with the compass.

Passo 2  ¶ 

Remove the bracket.

Passo 2  ¶ 

  • Remove the bracket.

Passo 3  ¶ 

Remove the two screws securing the rear camera module cover plate: One 1.8 mm Phillips screw

Passo 3  ¶ 

  • Remove the two screws securing the rear camera module cover plate:

  • One 1.8 mm Phillips screw

  • One 2.7 mm (nonferrous) standoff screw

  • Standoff screws are best removed using an iPhone Standoff Screwdriver Bit and driver handle.

  • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage nearby components.

Passo 4  ¶ 

Remove the cover plate from the rear camera module.

Passo 4  ¶ 

  • Remove the cover plate from the rear camera module.

Passo 5  ¶ 

Use an iFixit opening tool or a fingernail to disconnect the two camera cable connectors by prying them straight up from their sockets. Use an iFixit opening tool or a fingernail to disconnect the two camera cable connectors by prying them straight up from their sockets. Use an iFixit opening tool or a fingernail to disconnect the two camera cable connectors by prying them straight up from their sockets.

Passo 5  ¶ 

  • Use an iFixit opening tool or a fingernail to disconnect the two camera cable connectors by prying them straight up from their sockets.

Passo 6  ¶ 

Use the flat end of a spudger to pry up the rear-facing camera assembly from the top edge of the iPhone. If you have trouble, switch to the point of your spudger and lever the camera out from its top right corner. If you have trouble, switch to the point of your spudger and lever the camera out from its top right corner.

Passo 6  ¶ 

  • Use the flat end of a spudger to pry up the rear-facing camera assembly from the top edge of the iPhone.

  • If you have trouble, switch to the point of your spudger and lever the camera out from its top right corner.

Passo 7  ¶ 

Remove the rear-facing camera assembly.

Passo 7  ¶ 

  • Remove the rear-facing camera assembly.