Salta al contenuto principale
Aiuto

Nostalgia Electrics RHP-310 Replacing Fan Replacement

Pallini!

Pallini!

Un migliore coordinamento tra i markup e il colore/tipo dei pallini aiuterà a rendere più chiara questa guida!

Testo Confuso

Testo Confuso

Parte del testo di questa guida è confusionario, doppio, o fuori tema. Modificarlo per renderlo più chiaro!

Use this guide to replace the fan inside the popper.

  • Autore: Dana Clarke
  • Stima il tempo: 20 - 25 minuti
  • Difficoltà: Moderato

This guide will outline how to replace the fan inside the heating component.

Passo 1 Replacing Fan  ¶ 

Now that the white top is disconnected from the housing, remove the heating component from inside the device.

Passo 1 Replacing Fan  ¶ 

  • Now that the white top is disconnected from the housing, remove the heating component from inside the device.

Passo 2  ¶ 

Unscrew the three screws (10 mm Philips #2 screws) that hold the heating component together.

Passo 2  ¶ 

  • Unscrew the three screws (10 mm Philips #2 screws) that hold the heating component together.

Passo 3  ¶ 

Make sure to keep the screws.  You will need them to put the heating component back together.

Passo 3  ¶ 

  • Make sure to keep the screws. You will need them to put the heating component back together.

  • Pull the heating component apart.

Passo 4  ¶ 

Locate the fan. Pull the fan off the motor firmly but gently.

Passo 4  ¶ 

  • Locate the fan.

  • Pull the fan off the motor firmly but gently.

  • When you pull the fan off the motor, be careful. Do not pull to hard or you will break the motor.

Passo 5  ¶ 

You can now replace the fan.

Passo 5  ¶ 

  • You can now replace the fan.

  • If there is debris stuck in the fan, you can easily clean it out from the fan in this step.