Salta al contenuto principale
Aiuto

GoPro Karma Landing Gear Replacement

Replace the landing gear in your GoPro Karma.

  • Autore: Jay Ingram
  • Stima il tempo: 10 - 15 minuti
  • Difficoltà: Facile

Use this guide to remove and replace your broken landing gear. It will show you how to remove the entire assembly safely for replacement. This may be needed if broken on a rough landing.

Passo 1 Landing Gear  ¶ 

Flip the drone upside down with the landing gear out.

Passo 1 Landing Gear  ¶ 

  • Flip the drone upside down with the landing gear out.

  • Remove the four 1.2 cm long hex screws with a Hex 2.0 screwdriver in the four corners of the landing gear

Passo 2  ¶ 

Push with your thumb and pull up with your fingers to remove the landing gear.

Passo 2  ¶ 

  • Push with your thumb and pull up with your fingers to remove the landing gear.

  • Caution: The landing gear is connected by a thin cable so do not pull too far away.

Passo 3  ¶ 

Flip over the landing gear and locate the cable connector. Use your thumbnail to disconnect the cable and free the landing gear.

Passo 3  ¶ 

  • Flip over the landing gear and locate the cable connector.

  • Use your thumbnail to disconnect the cable and free the landing gear.