Salta al contenuto principale
Aiuto

Neato Botvac D8000 Wheel Replacement

This is a step by step guide on how to replace the wheel

  • Autore: Ruth Lopez
  • Stima il tempo: 20 minuti
  • Difficoltà: Moderato

This guide will allow the user to entirely remove the wheel from the device.

Sezioni

Passo 1 Wheel  ¶ 

Locate the screws that mount the wheel extension to the Robot. Unscrew the four 11mm screws indicated with a Torx T10 screwdriver to remove the frame. Make sure to remove the metallic weight. However, this does not require the removal of any screws.

Passo 1 Wheel  ¶ 

  • Locate the screws that mount the wheel extension to the Robot.

  • Unscrew the four 11mm screws indicated with a Torx T10 screwdriver to remove the frame.

  • Make sure to remove the metallic weight. However, this does not require the removal of any screws.

Passo 2  ¶ 

Delicately lift up the frame holding the laser. This will access the wheels. Detach the wheel wires that are connected to the motherboard. Once the wires are detached, the wheel are free from their casing.

Passo 2  ¶ 

  • Delicately lift up the frame holding the laser. This will access the wheels.

  • Detach the wheel wires that are connected to the motherboard.

  • Once the wires are detached, the wheel are free from their casing.

Passo 3  ¶ 

Use a Torx T15 screwdriver to remove the 32.5mm screw. Finally, just hold and separate the wheel from its axle.

Passo 3  ¶ 

  • Use a Torx T15 screwdriver to remove the 32.5mm screw.

  • Finally, just hold and separate the wheel from its axle.