Salta al contenuto principale
Aiuto

Samsung NP510R5E-A01UB Display Replacement

This guide will show you how to replace the display for a Samsung NP510R5E-A01UB.

  • Autore: Dominic Simpson
  • Stima il tempo: 10 - 15 minuti
  • Difficoltà: Moderato

The display for a device gives visual output for the user to interact with. This guide will help you replace it properly.

Passo 1 Display  ¶ 

Remove the two  rubber feet with arrows by them on the back side to uncover two screws. Unscrew the four silver 4.4mm long screws near the hard drive. Unscrew the remaining nine black 6.5mm long screws. Then remove the back casing using a pry tool if needed.

Passo 1 Display  ¶ 

  • Remove the two rubber feet with arrows by them on the back side to uncover two screws.

  • Unscrew the four silver 4.4mm long screws near the hard drive.

  • Unscrew the remaining nine black 6.5mm long screws. Then remove the back casing using a pry tool if needed.

Passo 2  ¶ 

Disconnect the black and white cables by pulling up as pictured. Disconnect the black and white cables by pulling up as pictured.

Passo 2  ¶ 

  • Disconnect the black and white cables by pulling up as pictured.

Passo 3  ¶ 

Disconnect the black cable by pulling straight out. Disconnect the black cable by pulling straight out.

Passo 3  ¶ 

  • Disconnect the black cable by pulling straight out.

Passo 4  ¶ 

Unscrew the two 4.45mm long screws to disconnect the left hinge. Unscrew the two 4.45mm long screws to disconnect the right hinge. At this point the screen and plastic housing should be completely disconnected.

Passo 4  ¶ 

  • Unscrew the two 4.45mm long screws to disconnect the left hinge.

  • Unscrew the two 4.45mm long screws to disconnect the right hinge.

  • At this point the screen and plastic housing should be completely disconnected.

Passo 5  ¶ 

Using the plastic opening tool, pry open the plastic housing that holds the display. Using the plastic opening tool, pry open the plastic housing that holds the display.

Passo 5  ¶ 

  • Using the plastic opening tool, pry open the plastic housing that holds the display.

Passo 6  ¶ 

Unscrew the four 3.55mm long screws that hold the display in place. Unscrew the four 3.55mm long screws that hold the display in place.

Passo 6  ¶ 

  • Unscrew the four 3.55mm long screws that hold the display in place.

Passo 7  ¶ 

Disconnect the last cable by pulling straight out. Disconnect the last cable by pulling straight out.

Passo 7  ¶ 

  • Disconnect the last cable by pulling straight out.