Salta al contenuto principale
Aiuto

DBPOWER RD-810 Power Supply Circuit Replacement

Remove the Power Supply Circuit to access the power supply switch.

  • Autore: John Russell
  • Stima il tempo: 10 minuti
  • Difficoltà: Facile

The power supply circuit controls the flow of electricity into the projector. If the projector is not turning on, the Power Supply Circuit may need to be replaced.

This guide can also be used to allow access to the power supply switch.

Passo 1 Power Supply Circuit  ¶ 

Remove the two 9mm PH2 phillips head screws. Lift the mirror behind the power supply circuit out to gain access to the circuit board. Lift the mirror behind the power supply circuit out to gain access to the circuit board.

Passo 1 Power Supply Circuit  ¶ 

  • Remove the two 9mm PH2 phillips head screws.

  • Lift the mirror behind the power supply circuit out to gain access to the circuit board.

Passo 2  ¶ 

Lift the power supply circuit board out of the projector. Disconnect the cable connector by pulling the two sides of the connector apart.

Passo 2  ¶ 

  • Lift the power supply circuit board out of the projector.

  • Disconnect the cable connector by pulling the two sides of the connector apart.

  • Keep the connector parallel to the circuit board to avoid breaking the solder connection.