Salta al contenuto principale
Aiuto

Dell Alienware 13 R3 Base Cover Replacement

Guida con Contributo Membro

Guida con Contributo Membro

Uno straordinario membro della nostra comunità ha realizzato questa guida. Non è gestita dallo staff iFixit.

In this guide, we will show how to remove and replace the Base Cover.

  • Autore: Terrence15
  • Stima il tempo: 4 - 20 minuti
  • Difficoltà: Facile

In this guide, we will show how to remove and replace the Base Cover.

Passo 1 Loosen the Screws  ¶ 

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.

Passo 1 Loosen the Screws  ¶ 

  • WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.

  • Loosen the five captive screws that secure the base cover to the computer base.

Passo 2 Pry the Base Cover  ¶ 

Using a plastic scribe, gently pry the base cover to release the tabs on the base cover from the slots on the computer base.

Passo 2 Pry the Base Cover  ¶ 

  • Using a plastic scribe, gently pry the base cover to release the tabs on the base cover from the slots on the computer base.

Passo 3 Lift the Base Cover  ¶ 

Lift the base cover off the computer base.

Passo 3 Lift the Base Cover  ¶ 

  • Lift the base cover off the computer base.

Passo 4 Disconnect the Battery Cable  ¶ 

Using a plastic scribe, disconnect the battery cable from the system board.

Passo 4 Disconnect the Battery Cable  ¶ 

  • Using a plastic scribe, disconnect the battery cable from the system board.

Passo 5 Press and Hold the Power-Button  ¶ 

Nessuna immagine

Passo 5 Press and Hold the Power-Button  ¶ 

  • Press and hold the power button for five seconds to ground the system board.

Passo 6 Connect the Battery Cable  ¶ 

Nessuna immagine

Passo 6 Connect the Battery Cable  ¶ 

  • Connect the battery cable to the system board.

Passo 7 Slide the Tabs  ¶ 

Slide the tabs on the NEW base cover into the slots on the computer base and snap the base cover into place

Passo 7 Slide the Tabs  ¶ 

  • Slide the tabs on the NEW base cover into the slots on the computer base and snap the base cover into place

Passo 8 Tighten the Five Captive Screws  ¶ 

Tighten the five captive screws that secure the base cover to the computer base.

Passo 8 Tighten the Five Captive Screws  ¶ 

  • Tighten the five captive screws that secure the base cover to the computer base.