Salta al contenuto principale
Aiuto

HP Envy x360 15-u473cl Battery Replacement

Replace your dying or dead battery to bring power back to your HP Envy x360 laptop.

The battery can stop holding a charge or die completely. This guide will show how to remove the battery inside the device.

Passo 1 Battery  ¶ 

Power off your laptop before beginning disassembly. Pry off the 2 rear rubber pads (closest to the laptop hinge) using the plastic opening tool to reveal two screws.

Passo 1 Battery  ¶ 

  • Power off your laptop before beginning disassembly.

  • Pry off the 2 rear rubber pads (closest to the laptop hinge) using the plastic opening tool to reveal two screws.

  • Remove the 2 anti-tamper proof covers using the spudger to reveal two screws.

Passo 2  ¶ 

Remove the fourteen 7mm screws using the Phillips #0 screwdriver from the bottom of the laptop.

Passo 2  ¶ 

  • Remove the fourteen 7mm screws using the Phillips #0 screwdriver from the bottom of the laptop.

Passo 3  ¶ 

Turn the device right side up and open the lid. Insert the plastic opening tool in between the keyboard plate and the base of laptop.

Passo 3  ¶ 

  • Turn the device right side up and open the lid.

  • Insert the plastic opening tool in between the keyboard plate and the base of laptop.

  • Run the tool along seem, prying up as you go.

  • Separate the keyboard plate from the base, lifting from the front.

Passo 4  ¶ 

There are 3 ribbon cables (black, white, and copper color) connecting the computer to the keyboard plate. Disconnect the 3 ribbon cables using the plastic opening tool by prying up the latches holding each cable in place.

Passo 4  ¶ 

  • There are 3 ribbon cables (black, white, and copper color) connecting the computer to the keyboard plate. Disconnect the 3 ribbon cables using the plastic opening tool by prying up the latches holding each cable in place.

  • Remove the keyboard plate from the device.

Passo 5  ¶ 

Remove the thick white ribbon cable covering the battery using the plastic opening tool by prying up the latches attaching each end.

Passo 5  ¶ 

  • Remove the thick white ribbon cable covering the battery using the plastic opening tool by prying up the latches attaching each end.

Passo 6  ¶ 

Remove the three 4mm screws using the Phillips #0 screwdriver.

Passo 6  ¶ 

  • Remove the three 4mm screws using the Phillips #0 screwdriver.

Passo 7  ¶ 

Disconnect the battery from the motherboard.

Passo 7  ¶ 

  • Disconnect the battery from the motherboard.

  • There may be tamper-proof tape holding the battery in place. Remove the tape if present.

  • Remove the battery from the device.