Salta al contenuto principale
Aiuto

Huawei Mate 8 Display Replacement

Replace the broken display of your Huawei Mate 8 smartphone.

Use this guide to replace the defective display of your Huawei Mate 8.

Passo 1 Display  ¶ 

Remove the four Phillips #00 screws holding the daughterboard and loudspeaker to the phone.

Passo 1 Display  ¶ 

  • Remove the four Phillips #00 screws holding the daughterboard and loudspeaker to the phone.

Passo 2  ¶ 

Use the flat end of a spudger to disconnect the loudspeaker connector cable. Use the tip of a spudger to lift the daughterboard from the phone.

Passo 2  ¶ 

  • Use the flat end of a spudger to disconnect the loudspeaker connector cable.

  • Use the tip of a spudger to lift the daughterboard from the phone.

Passo 3  ¶ 

Insert the flat end of a spudger under the loudspeaker at the gap on the left side. Work the spudger under the loudspeaker to seperate it from the adhesive and remove the loudspeaker.

Passo 3  ¶ 

  • Insert the flat end of a spudger under the loudspeaker at the gap on the left side.

  • Work the spudger under the loudspeaker to seperate it from the adhesive and remove the loudspeaker.

  • Use tweezers to take the vibration unit out of its housing.

Passo 4  ¶ 

Remove the eight Phillips #00 screws securing the motherboard to the phone.

Passo 4  ¶ 

  • Remove the eight Phillips #00 screws securing the motherboard to the phone.

Passo 5  ¶ 

Remove the bracket from the rear camera flex cable. Use tweezers to disconnect the antenna cable.

Passo 5  ¶ 

  • Remove the bracket from the rear camera flex cable.

  • Use tweezers to disconnect the antenna cable.

Passo 6  ¶ 

Use the flat end of a spudger to disconnect the volume and power flex cable on the bottom left side of the mainboard. Work the flat end of a spudger under the top right side of the mainboard to pry it out. Remove the mainboard.

Passo 6  ¶ 

  • Use the flat end of a spudger to disconnect the volume and power flex cable on the bottom left side of the mainboard.

  • Work the flat end of a spudger under the top right side of the mainboard to pry it out.

  • Remove the mainboard.

Passo 7  ¶ 

Remove the antenna interconnect cable. Remove the power and volume switch assembly.

Passo 7  ¶ 

  • Remove the antenna interconnect cable.

  • Remove the power and volume switch assembly.

Passo 8  ¶ 

Use tweezers to remove the earpiece speaker. Remove the red rubber gasket. Remove the ambient light and proximity sensor.

Passo 8  ¶ 

  • Use tweezers to remove the earpiece speaker.

  • Remove the red rubber gasket.

  • Remove the ambient light and proximity sensor.