Salta al contenuto principale
Aiuto

Insignia Ice Maker NS-IMP26SS7 Ice Tray Replacement

How to replace Ice tray on Insignia Ice Maker.

  • Autore: Evan Taylor
  • Stima il tempo: 30 minuti
  • Difficoltà: Moderato

This guide will show the required steps to replace the ice tray on the Insignia Ice Maker.

Passo 1 Water Tray  ¶ 

Remove the 6 screws holding the rear casing on. Remove the rear casing Remove the rear casing

Passo 1 Water Tray  ¶ 

  • Remove the 6 screws holding the rear casing on.

  • Remove the rear casing

Passo 2  ¶ 

Remove the 4 screws holding the Ice Tray to the body of the Ice Maker. Remove the 4 screws holding the Ice Tray to the body of the Ice Maker. Remove the 4 screws holding the Ice Tray to the body of the Ice Maker.

Passo 2  ¶ 

  • Remove the 4 screws holding the Ice Tray to the body of the Ice Maker.

Passo 3  ¶ 

Remove the 4 screws holding the Ice Tray from the top. Remove the 4 screws holding the Ice Tray from the top. Remove the 4 screws holding the Ice Tray from the top.

Passo 3  ¶ 

  • Remove the 4 screws holding the Ice Tray from the top.

Passo 4  ¶ 

Lift the Water Pump out of the way Lift the Water Pump out of the way

Passo 4  ¶ 

  • Lift the Water Pump out of the way

Passo 5  ¶ 

Remove the final 2 screws. Remove the final 2 screws. Remove the final 2 screws.

Passo 5  ¶ 

  • Remove the final 2 screws.

Passo 6  ¶ 

Remove the plastic cover from the circuit board by pressing the lever on the side. A pry tool may be required. Disconnect the water tray cord. Disconnect the water tray cord.

Passo 6  ¶ 

  • Remove the plastic cover from the circuit board by pressing the lever on the side. A pry tool may be required.

  • Disconnect the water tray cord.