Salta al contenuto principale
Aiuto

HP Envy x360 m6-aq005dx Touchpad Replacement

Use this guide to remove or replace the touchpad of your HP Envy x360 m6-aq005dx.

  • Autore: Darrin Smiley
  • Stima il tempo: 8 minuti
  • Difficoltà: Moderato

The touchpad is the component used to maneuver the cursor around the desktop and for making selections from various menus. This guide will provide detail directions for the proper removal of the touchpad.

Sezioni
Strumenti

Passo 1 Touchpad  ¶ 

Carefully, pull back the locking clip of the connector using a plastic opening tool and disconnect cable.

Passo 1 Touchpad  ¶ 

  • Carefully, pull back the locking clip of the connector using a plastic opening tool and disconnect cable.

Passo 2  ¶ 

The red square contains two screws side by side. Using a PH0 bit remove the 7 (2.8 mm) screws securing the touchpad to the device.

Passo 2  ¶ 

  • The red square contains two screws side by side.

  • Using a PH0 bit remove the 7 (2.8 mm) screws securing the touchpad to the device.

Passo 3  ¶ 

Keep the ribbon cable from interfering with touchpad removal. Use a plastic opening tool to pry up the touchpad.

Passo 3  ¶ 

  • Keep the ribbon cable from interfering with touchpad removal.

  • Use a plastic opening tool to pry up the touchpad.

  • Gently, pull out the touchpad from device.