Salta al contenuto principale
Aiuto

Lenovo IdeaPad 110-15IBR Optical Drive Replacement

This guide can be used to replace the optical drive

  • Autore: Saddam Alsinai
  • Stima il tempo: 5 minuti
  • Difficoltà: Molto facile

This guide shows how to replace the optical drive for the Lenovo IdeaPad 110-15IBR. The guide shows how to remove the back panel, remove the screws holding the drive in place, and removing the optical drive from the docking port.

Passo 1 Optical Drive  ¶ 

Before you proceed, make sure your computer is turned off and it's not connected to any power source. Using #1 Phillips screwdriver remove the 13 (9mmx6mm) screws holding the back.

Passo 1 Optical Drive  ¶ 

  • Before you proceed, make sure your computer is turned off and it's not connected to any power source.

  • Using #1 Phillips screwdriver remove the 13 (9mmx6mm) screws holding the back.

  • Gently pry the back off using a plastic opening tool, starting from one of the corners.

Passo 2  ¶ 

Using #1 Phillips screwdriver remove the 1 (9mmx6mm) screw holding the disk drive in place.

Passo 2  ¶ 

  • Using #1 Phillips screwdriver remove the 1 (9mmx6mm) screw holding the disk drive in place.

Passo 3  ¶ 

Pull the optical drive away from device to slide out of dock.

Passo 3  ¶ 

  • Pull the optical drive away from device to slide out of dock.

  • Careful not to pull the drive straight up or towards the device, otherwise damage might be done to the drive connector.