Salta al contenuto principale
Aiuto

MSI GS63VR 7RF Stealth Pro SSD Replacement

How to replace the SSD in the MSI GS63VR 7RF Stealth Pro.

Solid state drives are built to make the device super fast. Don't be content waiting minutes for something that would take seconds. If you believe you need to replace your SSD, here is how to do it.

Sezioni

Passo 1 SSD  ¶ 

First, locate all the ribbon cables that are connected to the motherboard. Lift the ribbon cable connector tabs with the spudger gently. Using the tweezers, gently pull back on the ribbon cable until it is completely out of the socket.

Passo 1 SSD  ¶ 

  • First, locate all the ribbon cables that are connected to the motherboard.

  • Lift the ribbon cable connector tabs with the spudger gently.

  • Using the tweezers, gently pull back on the ribbon cable until it is completely out of the socket.

  • Be very gentle while dealing with ribbon cables. If one gets damaged the component it links to will not function.

Passo 2  ¶ 

First, locate all the screws holding down the Motherboard.

Passo 2  ¶ 

  • First, locate all the screws holding down the Motherboard.

  • Remove all the screws using the #1 Phillips head screw driver.

Passo 3  ¶ 

Next, locate the Wi-Fi chip. Use the #1 Phillips head screwdriver to remove the screw attaching the Wi-fi chip to the motherboard.

Passo 3  ¶ 

  • Next, locate the Wi-Fi chip.

  • Use the #1 Phillips head screwdriver to remove the screw attaching the Wi-fi chip to the motherboard.

Passo 4  ¶ 

Use the spudger to lift the motherboard up and remove it from the laptop, then flip the now separated motherboard over. Using tweezers, disconnect the red wire circled in the picture; where the hard drive would be. Locate the SSD and the screw holding it in.

Passo 4  ¶ 

  • Use the spudger to lift the motherboard up and remove it from the laptop, then flip the now separated motherboard over.

  • Using tweezers, disconnect the red wire circled in the picture; where the hard drive would be.

  • Locate the SSD and the screw holding it in.

  • Unscrew the one Screw using a #1 Phillips Head screwdriver.

  • The SSD will want to lift with that screw being removed, from here grab it and pull it out gently.