Aggiusta la tua roba Comunità Store

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

bObi Robotic Vacuum Main Brush Motor Replacement

Introduzione

How to remove and replace the motor for bObi's main brushes.

Cosa ti serve

  1. bObi Robotic Vacuum Main Brush Motor Replacement, Main brush motor: passo 1, immagine 1 di 3 bObi Robotic Vacuum Main Brush Motor Replacement, Main brush motor: passo 1, immagine 2 di 3 bObi Robotic Vacuum Main Brush Motor Replacement, Main brush motor: passo 1, immagine 3 di 3

    • Remove bObi's dustbin. Press the small latch on the back and it will pop out.

    • Uninstall the 2 screws close to bObi’s dustbin, plus 2 smaller screws above the main brushes.

    Traduci

  2. bObi Robotic Vacuum Main Brush Motor Replacement: passo 2, immagine 1 di 3 bObi Robotic Vacuum Main Brush Motor Replacement: passo 2, immagine 2 di 3 bObi Robotic Vacuum Main Brush Motor Replacement: passo 2, immagine 3 di 3

    • To detach the brushes completely, unplug them from bObi.

    • The motor is on the bottom of the main brush attachment. Uninstall the four screws which secure it, then lift the motor out.

    • Remove the stabilizer attached to the motor’s end, closer to its circuit plug before pulling the whole piece out.

    Traduci

  4. bObi Robotic Vacuum Main Brush Motor Replacement: passo 3, immagine 1 di 3 bObi Robotic Vacuum Main Brush Motor Replacement: passo 3, immagine 2 di 3 bObi Robotic Vacuum Main Brush Motor Replacement: passo 3, immagine 3 di 3

    • Slide the long metal end in first, through the second stabilizer, so the end fits inside the motor holder.

    • Place the stabilizer you removed previously on the new motor.

    Traduci

  5. bObi Robotic Vacuum Main Brush Motor Replacement: passo 4, immagine 1 di 2 bObi Robotic Vacuum Main Brush Motor Replacement: passo 4, immagine 2 di 2

    • Align the stabilizer with the screw posts on the brush holder, then install all four screws.

    • Connect the motor’s circuit plug.

    • Place the main brush attachment in bObi so it sits flat.

    • Line up the red fastener on bObi, and replace its two smaller screws.

    Traduci

  6. bObi Robotic Vacuum Main Brush Motor Replacement: passo 5, immagine 1 di 2 bObi Robotic Vacuum Main Brush Motor Replacement: passo 5, immagine 2 di 2

    • Lay the two screw holders down. Then install each screw.

    • Slide bObi's dustbin back in until it locks in place.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 3 altri collaboratori

Chelsea

Membro da: 09/24/14

2.278 Reputazione

31 Guide realizzate

Distintivi: 11

+8 altri distintivi

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 308