Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the power plug located on the back of the massage pillow.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unzip the cover. You can locate the zipper at the back of the massage pillow.
-
Take out the pillow so that you can manage the heater completely.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips JIS #1 screwdriver to remove the screw at the center of the heater.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the entire heater from the pillow.
-
You can see a green circuit board after removing the heater.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the Phillips JIS #1 screwdriver, remove the three screws circled in the picture.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Now you can take out the circuit board. There will be two wires attached to the circuit board.
-
If you prefer, you can clean the circuit board gently with dry tissues to remove the sticky lubricant.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the pry bar to separate the wire from the white main board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using your soldering station, remove the wires from the circuit board.
-
Now, you can separate the circuit board completely to replace with a new heater.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.
2 Commenti
Hi YuChen, nice work! Do you know from where I can find the switch for this heater? If you can tell me the part number, I can try looking it up on eBay. Thanks!