Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the device over with its display down.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the battery cover, pressing down on the tabs and sliding.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the two (2) #00, 10 mm screws located below the mic on the back cover.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully pry up the top end of the back cover using one finger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the back plate by using a plastic removal tool to pry the back cover up around the edges.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
De-solder the white and black speaker wires from their soldering points.
-
Speaker soldering points are located on the thin section of the blue circuit board, and are marked with “SP+” and “SP-”.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the damaged speaker from its place at the very bottom of the case, just below the battery input.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Replace the damaged speaker and re-solder to the original solder points.
-
Ensure that the negative wire is soldered to the “SP-” while the positive wire is soldered to the “SP+” point.
-