Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the battery cover, pressing down on the tabs and sliding.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the two (2) #00, 10 mm screws located below the mic on the back cover
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully pry up the top end of the back cover using one finger
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the back plate by using a plastic removal tool to pry the back cover up around the edges.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place new lead in at point one and re-solder at the point.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place second lead at point 2 and re-solder.
-
7 Commenti
Caution is needed with step 5. My backside broke off using a spudger to attempt to remove.
Mine has third screw under the serial-number sticker.
Can anyone advise where to find replacement terminals? My zoom h1 has bad corrosion of its battery terminals and I would like to follow this guide to fix them! Thanks!