Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two screws from the end of the device where the ports are located using a Phillips #1 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the tablet down so that the screen is facing away from you.
-
Insert the tip of your opening tool into the small gap between the gray and white plastic covering. Pry it open and you should hear the clips opening up.
-
Gently work your way around the perimeter of the tablet's edge.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the back cover
-
Remove any tape on the speaker and detach the speaker from the back plate.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the Wi-Fi antenna cable from the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the Phillips #1 screwdriver, remove the three screws from the motherboard..
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Open the ZIF connector. Then, remove the ribbon that connects the motherboard and the screen.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the other ZIF connector on the opposite side of the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the motherboard and now reinsert all connectors into a new motherboard.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.