Introduzione

How to remove the screen for the ZTE ZMAX Z970. Removing the screen is easiest with an iOpener which requires a microwave.

  1. Insert a fine point tool into the hole on the top left side of the phone to remove the SIM and SD card trays.
    • Insert a fine point tool into the hole on the top left side of the phone to remove the SIM and SD card trays.

    • Pull out the trays.

    Aggiungi Commento

  2. Insert a plastic opening tool into the groove between the phone’s back cover and casing.
    • Insert a plastic opening tool into the groove between the phone’s back cover and casing.

    • Move the plastic opening tool along the edges of the phone to unclip the two pieces.

    Aggiungi Commento

    • Remove the ten 1.2mm screws with a Phillips #000 screwdriver.

    Aggiungi Commento

    • Remove the mid frame with the plastic opening tool.

    Aggiungi Commento

    • Disconnect the battery from the motherboard.

    Aggiungi Commento

    • Wedge a spudger underneath the battery and gently pry upwards to remove the battery.

    • Once free from the glue, remove from device.

    • The glue holding down the battery is strong so work slow and cautiously to avoid starting a fire.

    Aggiungi Commento

    • Heat up the iOpener for 30 seconds and place on top of the phone for 2 minutes.

    Aggiungi Commento

    • Wedge the opening picks into all the corners of the phone and lift until the screen comes off.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Ismail Jhaveri

Membro da: 15/02/2018

135 Reputazione

1 Guida realizzata

Team

USF Tampa, Team S17-G3, Boczar Spring 2018 Membro di USF Tampa, Team S17-G3, Boczar Spring 2018

USFT-BOCZAR-S18S17G3

3 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 45

Tutti i Tempi: 372