Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the battery cover toward the top of the controller to remove it.
-
Lift up the batteries or the battery pack from the battery compartment.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert a plastic opening tool into the top seam, and gently work the opening tool to the bottom of the controller.
-
Continue using the opening tool to gently pry the side plate off of the controller.
-
Repeat this process for the second side plate.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently peel the battery label or punch a hole in the center of the sticker in the battery compartment to reveal the hidden screw.
-
Remove the five 9mm torx-9 security screws from the back of the controller.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Tape the Rumbler/shock motors in place.
-
This will prevent the motors from falling out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Orient the controller so the front plate is facing up.
-
Lift the front cover off of the controller.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the controller face down and gently lift the rear plate.
-
Annulla: non ho completato questa guida.
Altre 49 persone hanno completato questa guida.
4 Commenti
T9 is VERY snug. T8 would probably be better but I don’t have one to try.
T9 barely fits, I couldn’t even get 2 of the screws to turn. I think T8 works better
One frustrating thing. All the guides I find on iFixit never give tips on reassembly. I'm having a difficult time getting the back plate back on. No help here, unfortunately.