Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Premi il pulsante di rilascio della batteria sulla parte superiore del controller.
-
Rimuovi il supporto della batteria dal controller.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Tweezers$4.99-
Use a pair of tweezers to peel the barcode sticker from the battery compartment.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the seven 9.3 mm T8 Security Torx screws securing the rear case to the front case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Spudger$2.99-
Insert a Spudger between the front and rear cases along the left edge of the controller.
-
Rotate the spudger toward the front of the controller, prying the two cases apart.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert a spudger between the front and rear cases, near the headphone jack.
-
Rotate the spudger toward the front of the controller to pry the two cases apart.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Grasp the controller by the battery compartment and the headphone jack.
-
Lift the battery compartment away from the headphone jack, separating the rear case from the front case and logic board.
-
Annulla: non ho completato questa guida.
Altre 22 persone hanno completato questa guida.