Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
To begin, ensure MiPosaur is off, and loosen the screws on the battery compartment.
-
The battery compartment will detach from the device once all screws have been loosened.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once the battery compartment is removed, remove the screws on the side of the body.
-
Remove the blue plastic tabs at the base of the tail and at the mouth joint on the same side of the body.
-
Remove the screws hidden underneath these tabs, and pull lightly on the body to open it.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the screws on the power board and motherboard, and lift the motherboard up.
-
On the underside of the motherboard, trace the wires of the faulty leg to the appropriate connector.
-
Remove the plug from the connector.
-
Remove the screws around the base of the circular opening in the body.
-
Twist the leg slightly and remove it from the body, routing the wire through the large opening.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
After the leg has been removed from the body, remove the screws securing the wheel covers.
-
With the wheel exposed, hold it down firmly, so it does not rotate, and remove the screw in the center. This can be difficult to remove.
-
Remove the screws from the leg, including the screws hidden underneath the wheel.
-
Remove the rear casing from the leg, routing the wire through the large opening.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once the leg has been opened, remove the wire lock by unscrewing it from the front casing.
-
Remove the gearbox from its holster.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
A Ferris wheel-shaped part should be connected to the gearbox motor's axle. Ensure it is not loosely connected or missing. If loose, push it further down the axle and into place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the gearbox back in its holster and secure the wiring with the wire lock.
-
Route the wiring through the hole in the rear casing, and reattach all screws.
-
Reattach the wheel to the leg and secure it with the screw.
-
Reconnect the wheel covers and attach the screws.
-
Route the wires through the opening in the body, and reattach it to the connector.
-
Reattach the screws securing the motherboard and power board.
-
Slide the LED Mood Indicator cover and tail markings into their corresponding slots, and close the body.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Secure the body together with the remaining screws.
-
Reattach the two blue tabs, and screw in the battery compartment.
-