Salta al contenuto principale

Ricambi

Nessuna parte specificata.

  1. Place the Smart Watch on its back or side so that the full watch band is visible. Place the Smart Watch on its back or side so that the full watch band is visible.
    • Place the Smart Watch on its back or side so that the full watch band is visible.

  2. Remove the wrist strap by gently pulling the band off of the plastic pegs on the back of the watch.
    • Remove the wrist strap by gently pulling the band off of the plastic pegs on the back of the watch.

  3. Remove the four screws in the back of the watch using a Phillips #0 screwdriver.
    • Remove the four screws in the back of the watch using a Phillips #0 screwdriver.

  4. Gently pull off the back side of the watch component.
    • Gently pull off the back side of the watch component.

  5. Pull the battery and motherboard component out.
    • Pull the battery and motherboard component out.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

4 Commenti

What batteries does the smart band use?

Yourmajesty100 - Replica

Can be replaced by one of these and some soldering.

https://www.adafruit.com/product/1317

Alto -

This doesn’t detail sourcing the replacement or un-soldering then soldering the battery.

This is just “WowWee CHiP Robot Dog Smart Watch Battery Inspection” Not Replacement.

Alto - Replica

But the discussion is under battery replacement

Daniel peters -

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 13

Ultimi 30 Giorni: 40

Tutti i Tempi: 2,388