Introduzione

If you need to access the inside of your toaster to fix problems, start by removing the outer shell with this guide.

Parti

Nessuna parte richiesta.

  1. Using a wedge, pry off the rubber pieces on the bottom of each foot of the toaster.
    • Using a wedge, pry off the rubber pieces on the bottom of each foot of the toaster.

    Aggiungi Commento

  2. Remove the eight 8mm screws on each toaster foot using a Tri-point Y1 screwdriver.
    • Remove the eight 8mm screws on each toaster foot using a Tri-point Y1 screwdriver.

    Aggiungi Commento

    • Remove the crumb collector located on the bottom of the toaster.

    Aggiungi Commento

    • Remove the three 8mm screws using the Tri-point Y1 screwdriver.

    Aggiungi Commento

    • Remove the two 8mm screws on the bottom of the slide lever using a Tri-point Y1 screwdriver.

    • Once the screws are removed, detach the black plastic cover on the bottom of the slide lever.

    Aggiungi Commento

    • Remove the final 8mm screw in the slide lever.

    • The lever can now pull away from the entire unit.

    Aggiungi Commento

    • Remove toaster's outer shell by lifting straight up.

    • Slowly remove the outer shell. Disconnect ground wire before fully separating the shell and inner components.

    Aggiungi Commento

    • Disconnect the wire cluster that connects the lights and circuit board by pulling apart the two plastic connectors.

    • Remove the outer shell from the device.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Ryan Funchess

Membro da: 19/04/2018

697 Reputazione

5 Guide realizzate

Team

Cal Poly, Team S22-G5, Maness Spring 2018 Membro di Cal Poly, Team S22-G5, Maness Spring 2018

CPSU-MANESS-S18S22G5

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 4

Tutti i Tempi: 76