Introduzione

If your blender is leaking or making strange noises, consider replacing the O-ring.

  1. Flip over the pitcher to expose the base of the blade assembly.
    • Flip over the pitcher to expose the base of the blade assembly.

    • Using the H4.0 Allen key from the 54 bit driver kit, attached to an impact driver, remove the socket head cap screw from the drive coupling.

    • Apply a solvent to remove adhesive if necessary.

    Aggiungi Commento

  2. Using a pair of pliers, pull of the drive shaft coupling.
    • Using a pair of pliers, pull of the drive shaft coupling.

    Aggiungi Commento

    • Using a flat head screwdriver and a mallet, bend down the two tabs holding the large nut.

    Aggiungi Commento

    • Remove the nut using a crescent wrench.

    Aggiungi Commento

    • Push the blade assembly into the jar.

    • Remove the blades from the device.

    • Be careful not to cut yourself when handling the blades.

    Aggiungi Commento

    • Use tweezers to pull off the o-ring.

    • Be careful not to cut yourself while handling the blender blades.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Luke Kutz

Membro da: 19/04/2018

342 Reputazione

3 Guide realizzate

Team

Cal Poly, Team S25-G16, Maness Spring 2018 Membro di Cal Poly, Team S25-G16, Maness Spring 2018

CPSU-MANESS-S18S25G16

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 41