Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the base of the blender upside-down.
-
Remove the four 1/2" long screws in the corners of the base using a Phillips #2 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the metal spudger, pry off one half of each rubber foot.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the same screwdriver, remove the next four 1/2" long screws in the holes under the feet.
-
Pull the base off of the blender.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the same Phillips #2 screwdriver, remove the two 3/4" long screws holding the control board in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using pliers, pull off all the connectors on the top.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull or pry off the last connector block, then remove the control board.
-