Aggiusta la tua roba Comunità Store

Wolf Gourmet WGBL100S Control Board Replacement

Introduzione

If your blender does not operate, try opening it as per this guide and checking the wires on the control board. If that yields no results, consider replacing the board if possible.

Cosa ti serve

  1. Wolf Gourmet WGBL100S Control Board Replacement, Control Board: passo 1, immagine 1 di 2 Wolf Gourmet WGBL100S Control Board Replacement, Control Board: passo 1, immagine 2 di 2

    • Flip the base of the blender upside-down.

    • Remove the four 1/2" long screws in the corners of the base using a Phillips #2 screwdriver.

    Modifica

  2. Wolf Gourmet WGBL100S Control Board Replacement: passo 2, immagine 1 di 2 Wolf Gourmet WGBL100S Control Board Replacement: passo 2, immagine 2 di 2

    • Using the metal spudger, pry off one half of each rubber foot.

    • Note that one side of the foot is glued down; pry off the other side.

    Modifica

  3. Wolf Gourmet WGBL100S Control Board Replacement: passo 3, immagine 1 di 1

    • Using the same screwdriver, remove the next four 1/2" long screws in the holes under the feet.

    • Pull the base off of the blender.

    Modifica

  5. Wolf Gourmet WGBL100S Control Board Replacement: passo 4, immagine 1 di 2 Wolf Gourmet WGBL100S Control Board Replacement: passo 4, immagine 2 di 2

    • Pull off the plastic housing.

    Modifica

  6. Wolf Gourmet WGBL100S Control Board Replacement: passo 5, immagine 1 di 2 Wolf Gourmet WGBL100S Control Board Replacement: passo 5, immagine 2 di 2

    • Using the same Phillips #2 screwdriver, remove the two 3/4" long screws holding the control board in place.

    Modifica

  7. Wolf Gourmet WGBL100S Control Board Replacement: passo 6, immagine 1 di 2 Wolf Gourmet WGBL100S Control Board Replacement: passo 6, immagine 2 di 2

    • Using pliers, pull off all the connectors on the top.

    Modifica

  8. Wolf Gourmet WGBL100S Control Board Replacement: passo 7, immagine 1 di 1

    • Pull or pry off the last connector block, then remove the control board.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 5 altri collaboratori

Cole Gillespie

Membro da: 04/19/18

476 Reputazione

2 Guide realizzate

Distintivi: 9

+6 altri distintivi

Team

Cal Poly, Team S25-G16, Maness Spring 2018 Membro di Cal Poly, Team S25-G16, Maness Spring 2018

CPSU-MANESS-S18S25G16

4 Membri

5 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 306