Salta al contenuto principale

Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.

Cosa ti serve

  1. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 1, immagine 1 di 3 : passo 1, immagine 2 di 3 : passo 1, immagine 3 di 3
    • Remove back cover & battery.

  2. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 2, immagine 1 di 2 : passo 2, immagine 2 di 2
    • Remove the front case by prying it open. You will hear clicks.

    • Be careful with taking off screen if you use a spudger.

  3. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 3, immagine 1 di 2 : passo 3, immagine 2 di 2
    • Use a Torx screwdriver to remove the screen screws.

    • Use a spudger or tweezers to remove the connector of the LCD screen.

  4. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 4, immagine 1 di 3 : passo 4, immagine 2 di 3 : passo 4, immagine 3 di 3
    • The PCB board had water damage, see this in picture 3.

    • To remove the corrosion, dab a cotton swab with a little distilled water on the corroded area, the corrosion will disappear.

  5. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 5, immagine 1 di 2 : passo 5, immagine 2 di 2
    • How and where to use the cotton swabs.

Linea Traguardo

Altre 17 persone hanno completato questa guida.

Kevin D

Membro da: 05/02/14

7.294 Reputazione

21 Guide realizzate

4 Commenti

no use .it is not switching on . replaced with good batter also. no on

nabhan75 - Replica

try to clean with an ultrasonic bath.

measure out powerrail.

measure out the voltage coming in on board. try to see if you have short.

Kevin D - Replica

Nokia 206 display and charger pin

Mithilesh Yadav - Replica

Not working kiy 1.2.3 and colling ricev kiy not working

K .M Jugesh - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 15

Ultimi 30 Giorni: 44

Tutti i Tempi: 10,796