Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Introduzione

Use this guide to replace the power switch on your device.

  1. Unscrew the 12 mm Phillips head screws located at the top of the cover and at the bottom two corners, using a Phillips #1 Screwdriver. Unscrew the 12 mm Phillips head screws located at the top of the cover and at the bottom two corners, using a Phillips #1 Screwdriver.
    • Unscrew the 12 mm Phillips head screws located at the top of the cover and at the bottom two corners, using a Phillips #1 Screwdriver.

  2. Unscrew the two black 5.556 mm Phillip head screw on the power switch with a Phillips #0 Screwdriver. Unscrew the two black 5.556 mm Phillip head screw on the power switch with a Phillips #0 Screwdriver.
    • Unscrew the two black 5.556 mm Phillip head screw on the power switch with a Phillips #0 Screwdriver.

  3. Shimmy the power switch off the mount until it is completely removed. Shimmy the power switch off the mount until it is completely removed. Shimmy the power switch off the mount until it is completely removed.
    • Shimmy the power switch off the mount until it is completely removed.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

USF Tampa, Team S14-G5, Boczar Fall 2017 Membro di USF Tampa, Team S14-G5, Boczar Fall 2017

USFT-BOCZAR-F17S14G5

2 Membri

5 Guide realizzate

Hello Mrs/ms Swearengin, I’m disassembled my Wahl desingner I’m unable to make the power switch stiff . It’s very loose I can’t recall which screw goes in between two black 5.556 mm Phillip head screw or if it needs a screw at all

Carlos Olvera - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 4

Tutti i Tempi: 302