Introduzione

Use this guide to replace the motor of your device.

Parti

Nessuna parte richiesta.

  1. Unscrew the 12 mm Phillips head screws located at the top of the cover and at the bottom two corners, using a Phillips #1 Screwdriver.
    • Unscrew the 12 mm Phillips head screws located at the top of the cover and at the bottom two corners, using a Phillips #1 Screwdriver.

    Aggiungi Commento

  2. Remove the wires connected to the motor by firmly grasping both sides of a wire and wiggling until it is released.
    • Remove the wires connected to the motor by firmly grasping both sides of a wire and wiggling until it is released.

    Aggiungi Commento

    • Unscrew the two 20.5 mm Phillip head screw located on the motor using a Phillip's #1 screwdriver.

    Aggiungi Commento

    • Gently remove the motor from the device.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

USF Tampa, Team S14-G5, Boczar Fall 2017 Membro di USF Tampa, Team S14-G5, Boczar Fall 2017

USFT-BOCZAR-F17S14G5

2 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 11

Tutti i Tempi: 97