Introduzione

Use this guide to remove the glass in the scanner bed in order to replace it.

Parti

Nessuna parte richiesta.

On the bottom of the scanner, remove the screw at the top left side.
  • On the bottom of the scanner, remove the screw at the top left side.

Aggiungi Commento

Remove the rubber foot pad opposite the screw hole to expose a second screw hole.
  • Remove the rubber foot pad opposite the screw hole to expose a second screw hole.

  • Remove the screw beneath the foot-pad.

Aggiungi Commento

  • Rotate the scanner so the screw hole is located on the top left hand side.

  • Place the plastic opening tool between the top casement and bottom casement of scanner with the hook facing up.

  • Gently pry the two casements apart beginning above the screw hole and working your way around.

  • Note that the top and bottom casings are held together by a series of 6 tabs. There is one tab on each of the long sides of the scanner approximately 6 inches in from the corners. There are two tabs on each of the short sides of the scanner approximately 2.3 inches in from the corners. Use the spudger to unhook the tab from the top casement.

Aggiungi Commento

  • Separate the two casement pieces.

Aggiungi Commento

  • Apply even pressure against the back of the glass while securing the plastic frame in place.

Aggiungi Commento

  • With consistent pressure on the glass, move your fingers down the sides until the glass is no longer stuck to the double-sided tape.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Jena

Membro da: 18/10/2013

608 Reputazione

6 Guide realizzate

Team

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 150