Aggiusta la tua roba Comunità Store

Vent/Bleed Coolant System on BMW E60/E90

Introduzione

If you are unsure that your car's battery will be strong to handle 12-15 minutes of the venting process attach a battery charger!

Panoramica Video

    • Insert key in the dash or steering column.

    Modifica

    • With foot OFF the brake (don't want to start the car), push the start button (headlamps and interior systems come on).

    Modifica

    • Turn both temp dials as high as they will go and put the fan on the lowest setting.

    Modifica

    • Push the accelerator pedal in for ten seconds then let go - you will hear the water pump cycle on.

    Modifica

    • Set a timer for 12-15 minutes. In this time period, you will hear the water pump cycle on and off and coolant gurgling at the reservoir.

    Modifica

    • After 12-15 minutes turn the car off, remove the reservoir cap and check the fluid - it should be slightly below where you started.

    Modifica

    • Start your car. Watch your temperature. If the car will run without overheating you're done. If you will notice that the temperature is rising repeat these steps.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Autore

con 3 altri collaboratori

lifeoftech

Membro da: 11/04/09

187 Reputazione

1 Guida realizzata

Distintivi: 6

+3 altri distintivi

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 13

Ultimi 7 Giorni: 89

Ultimi 30 Giorni: 496

Tutti i Tempi: 26,836