Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
At the breaker box, locate the breaker for the water heater. Switch the breaker bar to the off position.
-
Using a multimeter, check the line voltage at the water heater. The multimeter should read "0 VAC."
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a Phillips #0 screwdriver, remove the access panel (or panels) to access the thermostat and element.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Set aside the access panel cover and screws. Remove the insulation to expose the wires, thermostat, and element.
-
Disconnect the wiring from the electrical components in the panel.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Attach a hose to the drain valve located at the bottom of the tank, near the lower access panel. Place the other end of the hose in a safe location for the water to drain.
-
Open the drain valve on the water heater by turning it counter-clockwise.
-
Once you have a steady flow of water coming out of the hose, slowly close the cold water valve to the water heater by turning it clockwise.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using adjustable pliers, disconnect the water lines from the tank.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a pipe wrench, detach all remaining pipes from the tank.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.
Un commento
If you have enough assistance to transport the unit outside the house, taking apart an old water heater is simple. Components, mounting hardware, and other aspects of a water heater can all be removed independently. Nonetheless, it takes strength to pull the old water from its place and move it outside for proper disposal.