Aggiusta la tua roba Comunità Store

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Uniden TCX905 Earpiece Speaker Replacement

Introduzione

The earpiece is where the user hears the incoming call.

Cosa ti serve

  1. Uniden TCX905 Earpiece Speaker Replacement, Battery Cover: passo 1, immagine 1 di 2 Uniden TCX905 Earpiece Speaker Replacement, Battery Cover: passo 1, immagine 2 di 2

    • Starting from the top of the cover, slide down and away from the phone with your thumb

    • Lift battery cover off of batter and place it to the side

    Traduci

  2. Uniden TCX905 Earpiece Speaker Replacement, Battery Pack: passo 2, immagine 1 di 2 Uniden TCX905 Earpiece Speaker Replacement, Battery Pack: passo 2, immagine 2 di 2

    • Once battery cover is removed, place your thumb and index fingers on the the wires near the receptacle

    • Gently pull straight up on the wires until a click is heard which signifies the battery is completely disconnected

    • Place battery pack to the side

    Traduci

  3. Uniden TCX905 Earpiece Speaker Replacement, Back Shell: passo 3, immagine 1 di 2 Uniden TCX905 Earpiece Speaker Replacement, Back Shell: passo 3, immagine 2 di 2

    • Remove the two 11mm screws inside the battery storage compartment using Phillips #1 screwdriver (located near the very bottom of the phone)

    Traduci

  5. Uniden TCX905 Earpiece Speaker Replacement: passo 4, immagine 1 di 3 Uniden TCX905 Earpiece Speaker Replacement: passo 4, immagine 2 di 3 Uniden TCX905 Earpiece Speaker Replacement: passo 4, immagine 3 di 3

    • Gently open phone casing along the seam at the bottom of the phone using index and middle fingers of both hands

    Traduci

  6. Uniden TCX905 Earpiece Speaker Replacement: passo 5, immagine 1 di 3 Uniden TCX905 Earpiece Speaker Replacement: passo 5, immagine 2 di 3 Uniden TCX905 Earpiece Speaker Replacement: passo 5, immagine 3 di 3

    • Ensure that wired connection between circuit board and back shell is not strained

    • Fold the back shell underneath the front shell and circuit board

    Traduci

  7. Uniden TCX905 Earpiece Speaker Replacement, Circuit Board: passo 6, immagine 1 di 2 Uniden TCX905 Earpiece Speaker Replacement, Circuit Board: passo 6, immagine 2 di 2

    • Carefully remove the middle two 7mm screws, the outer top 9mm screws, and the top middle 7 mm screw that hold the logic board to the front shell of the phone casing using the Phillips #1 screwdriver

    Traduci

  8. Uniden TCX905 Earpiece Speaker Replacement: passo 7, immagine 1 di 3 Uniden TCX905 Earpiece Speaker Replacement: passo 7, immagine 2 di 3 Uniden TCX905 Earpiece Speaker Replacement: passo 7, immagine 3 di 3

    • Using index finger and thumb, carefully remove the circuit board from the front shell of phone

    Traduci

  9. Uniden TCX905 Earpiece Speaker Replacement, Earpiece Speaker: passo 8, immagine 1 di 2 Uniden TCX905 Earpiece Speaker Replacement, Earpiece Speaker: passo 8, immagine 2 di 2

    • Place circuit board gently on the back shell with the earpiece facing up

    Traduci

  10. Uniden TCX905 Earpiece Speaker Replacement: passo 9, immagine 1 di 3 Uniden TCX905 Earpiece Speaker Replacement: passo 9, immagine 2 di 3 Uniden TCX905 Earpiece Speaker Replacement: passo 9, immagine 3 di 3

    • Pry speaker gently from setting using tweezers

    • Cut red and black wires near the soldering

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 3 altri collaboratori

Gary Pence

Membro da: 03/26/14

807 Reputazione

8 Guide realizzate

Distintivi: 8

+5 altri distintivi

Team

Clemson, Team 1-1, Benson Spring 2014 Membro di Clemson, Team 1-1, Benson Spring 2014

CLEM-BENSON-S14S1G1

3 Membri

16 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 482